TOPOLOGY
1. ACCESS POINT
Enter your Routerboard
Your routerboard will be show
If you need. Reset your routerboard
Reset no default configuration
Yes to continue reset configuration
Your routerboard has been disconnected
Enter again
Open your terminal
Create IP Address in ether1
Create IP DNS with allow remote requests
Create firewall with chain "srcnat" and action "masqurade"
Ping internet (Google.com)
Enable your WLAN
WLAN has been enabled
Change wireless mode to ap-brigde
Start scanning
Change Frequency which you want and change SSID, if you need
Create IP Address to WLAN
Check registration.
Ping your client
Create IP Address to ether 2
Create IP Address to your computer / laptop
Ping internet and ether in routerboard
2. CLIENT 1
Enable your ethernet
Enter your routerboard
If you need, reset configuration
No default configuration for losing configuration
Routerboard has been disconnected
Enter the routerboard again
Enable WLAN
WLAN has been enabled
start scanning
Change WLAN mode to station and the frequency must similar with access point
Create IP Address to WLAN
Add gateway
Add IP DNS
Add Firewall
Ping internet (google.com)
Add IP Address to ether 2
Add IP Address to your computer / laptop
Ping Internet, your routerboard, and access point
3. CLIENT 2
Enable ethernet
Enter your routerboard
Reset configuration (if you need)
Yes to continue. and then the routerboard has been disconnected
Enter your routerboard again
Enable WLAN
WLAN has been enabled
Start scanning
Change mode and the frequency must similiar with access point
WLAN has been connected
Create IP Address in WLAN
Add Gateway
Add IP DNS
Add Firewall
Ping internet and access point
Create IP Address to ether 2
Create IP Address to your computer / laptop
Ping internet, routerboard, and access point
C. TRAFFIC OF DATA WHEN SHORT DISTANCE AND LONG DISTANCE
a. ACCESS POINT
1. SHORT DISTANCE
2. LONG DISTANCE
b. CLIENT 1
1. SHORT DISTANCE
2. LONG DISTANCE
c. CLIENT 2
1. SHORT DISTANCE
2. LONG DISTANCE
0 comments:
Post a Comment